[HECnet] Introduction

[Steve Davidson]

Mark,

Please post the file:

SYS$SPECIFIC:[SYSEXE]MODPARAMS.DAT

Then

$ DEFINE/USER SYS$OUTPUT MEMORY.TMP
$ SHOW MEM/FILE/FULL/ALL/PAGE

Then

$ DEFINE/USER/SYS$OUTPUT DECW.TMP
$ SHOW LOG DECW$*

Post the files MEMORY.TMP and DECW.TMP or send the whole thing to me
directly and I'll see what I can come up with.

If you have IP or DECnet running I can come in and look directly.

Regards,

-Steve

-----Original Message-----
From: owner-hecnet at Update.UU.SE [mailto:owner-hecnet at Update.UU.SE] On
Behalf Of Mark Benson
Sent: Wednesday, June 22, 2011 18:52
To: hecnet at Update.UU.SE
Subject: Re: [HECnet] Introduction


On 18 Jun 2011, at 09:21, H Vlems wrote:

Now I have a couple of VMS systems running which greatly improves my 
aging memory ;-) And will keep my electricity meter spinning a lot
faster too.

Sorry about the slow response, I have been doing a lot of RTFM and
trying to get used to the system. I also bought a HP zx6000 Itanium
workstation, but that's an aside for later ;)

The contents of the DECW$PRIVATE_SERVER-SETUP.COM file:

$ set verify
$ decw$server_page_file== 160000
$ decw$xsize_in_pixels == 1280
$ decw$ysize_in_pixels == 1024
$ define/exec/system/nolog decw$server_pixel_depth   24 $ 
define/exec/system/nolog decw$server_refresh_rate 75 $ set noverify

I got back to this eventually today. Still no luck. If I use your config
as you printed it it still crashes the whole machine dead at boot and I
have to enter a minimal boot and pull the file out to get any luck
booting again. Same as before.

I don't get what's goin on. :(


--
Mark Benson

My Blog:
<http://markbenson.org/blog>
Follow me on Twitter:
http://twitter.com/mdbenson

"Never send a human to do a machine's job..."