[HECnet] SIMH PDP-10 + Networking?

[G.]

On Sun, 23 Dec 2012 17:38:08 -0500, you wrote:

I have had no problem doing TOPS-10 MONGENs following that.

http://pastebin.com/LDUWrSEA is what happens

I'm not an expert at all in this things, but I can say that all those FTxxxx
symbols are feature switches which get set in F.MAC by MONGEN. Other multiply
defined symbols seem to be mostly from COMMON.MAC and COMMOD.MAC. Instead,
many of the undefined ones are from APRSER.MAC, i.e. the module that contains
most (all?) of the processor dependent code.

Maybe there is something wrong in your source setup or in your MONGEN answers.
I would try to follow the original Software Installation Guide (SIG), at least
chapter 9, which explains step-by-step what you should do, and also what to
answer to every MONGEN question. The most updated SIG can be found here:
http://pdp-10.trailing-edge.com/tops10v704_docc/01/10,7/docupd/sig.mem.html

Anyway, this is my (working) MONGEN.MIC: http://pastebin.com/z3Biz6rV
And this is the output from a build run: http://pastebin.com/qcMdyMXU

HTH, :)
G.