[HECnet] DECnet VMS <-> RSTS/E

Paul_Koning at Dell.com Paul_Koning at Dell.com
Mon Oct 29 07:01:06 PDT 2012


On Oct 29, 2012, at 3:26 AM, Jordi Guillaumes i Pons wrote:



Jordi Guillaumes i Pons
Barcelona - Catalunya - Europa

El 29/10/2012, a les 8:07, Dave McGuire <mcguire at neurotica.com> va escriure:
Going from RSTS/E to VMS via "SET HOST 61.2" gives me this:

---------------------------------------------
$ set host 61.2
Connection Established to VAX/VMS Node 61.2

?Unsupported Virtual Terminal Protocol.

I don't think you can use RTERM as an incoming protocol. And since you can't use it outgoing (from the Alpha) I guess it has been removed from Alpha VMS too...

There are two generations of terminal protocol (not counting LAT).   The newer of the two is Cterm, which is very large and very complicated.   VMS supports it, RSTS doesn't.   (I forgot if RSX does.)

The earlier one doesn't have a name as far as I remember.   Also, it isn't one protocol; instead, it's a separate protocol for each destination OS type.   The VMS and RSX flavors roughly correspond to the terminal QIO operations, you could think of them as a sort of RPC.   The RSTS one is a bit like telnet in that it comes with a simple line mode and a raw character mode.   The TOPS-20 one is just raw character mode.   All of these use the same DECnet object number, the distinction between the different protocols is made when you connect.

Also, the application installed on RSTS by default for Set Host ("net") is the RSTS-only subject of the older protocol.   The message you see comes from that application.   You need to install the "unsupported" multi-OS version ("netuns").   With that in place, it should be able to talk to any OS.

If VMS didn't have the older protocol listener in place, you'd get a different error message: a failure to connect due to the DECnet object not being defined at the destination.

	paul



More information about the Hecnet-list mailing list