[HECnet] DECSERVER 300 software?

[Johnny Billquist]

On 2013-05-07 19:50, Sampsa Laine wrote:

On 7 May 2013, at 19:46, Johnny Billquist <bqt at softjar.se> wrote:

Two things comes to mind - the fact that the LED is working shows that the basic system is just fine. If something is broken, it would only be port 1 in this case.
However, if you have a terminal connected to port 1, and the terminal have modem signalling enabled, it will not print anything. The DS does not activate the modem signals until it has booted. But there are data on the data lines before that...

	Johnny


It's doing the spinning LED now. I'll check the terminal settings and reboot it.

Spinning display means it has booted and everything is up and running.

	Johnny