[HECnet] RSX-11 booted!

[Johnny Billquist]

On 2014-05-22 15:02, Cory Smelosky wrote:
On Thu, 22 May 2014, Johnny Billquist wrote:

On 2014-05-22 14:57, Johnny Billquist wrote:
On 2014-05-22 14:52, Cory Smelosky wrote:
On Thu, 22 May 2014, Cory Smelosky wrote:

With the board in I can get to ODT...but:

QBUS BUS CONTROLLER TEST#1.......................... FAILED
  *** FAILED DUE TO UNINITIALIZED Q-BUS MAP, DMA FAILURE OR NON-EXIST
MEMORY.
QBUS BUS CONTROLLER TEST#2.......................... PASSED
QBUS BUS CONTROLLER TEST#3.......................... PASSED
QBUS SINGLE WORD DMA TEST........................... PASSED
QBUS TO FIFO DMA TEST............................... FAILED
  *** FAILED DUE TO UNINITIALIZED Q-BUS MAP, DMA FAILURE OR NON-EXIST
MEMORY.

I think the red ECC error light is on, too but the system IS halted.

That sounds bad. What backplane is this sitting in now? And I think the
PMI memory board actually do some internal diagnostics already at power
on, so an error light on is probably not a good sign...

By the way, I hope/assume that you also configured it to start at
address 0...


I have.   Took me a bit to figure out which DIP switch position meant
"on" and which meant "off".

:-)
So, what is the status now? It don't work?

	Johnny