[HECnet] Getting reconnected...

[Robert Jarratt]

The development branch of the code now compiles and runs on a Raspberry Pi. I have not given it a detailed test though, but anyone is welcome to try it. As it uses pcap run it with sudo.
The route20.ini file needs to be something like this:
  
[node]
level=2
address=5.99
name=A5RTR
priority=64
  
[ethernet]
interface=eth0
cost=3
  
[bridge]
address=psilo.update.uu.se:4711
port=4711
cost=5
  
; DNS section is optional, if not present then there is no periodic check to make sure
; that IP addresses have not changed. Note that the periodic checks do not cause any delay
; as they are done asynchronously.
[dns]
address=<your DNS address>
poll=<poll period in seconds>
  
Regards
  
Rob
  
From: owner-hecnet at Update.UU.SE [mailto:owner-hecnet at Update.UU.SE] On Behalf Of Robert Jarratt   Sent: 03 May 2014 10:46   To: hecnet at Update.UU.SE   Subject: RE: [HECnet] Getting reconnected...
  
I am working right now to get the code to compile and then work on a Raspberry Pi.
  
Regards
  
Rob
  
From: owner-hecnet at Update.UU.SE [mailto:owner-hecnet at Update.UU.SE] On Behalf Of Mark Benson   Sent: 03 May 2014 10:28   To: HECnet   Subject: Re: [HECnet] Getting reconnected...
  
  
On 2 May 2014, at 23:55, Gregg Levine <gregg.drwho8 at gmail.com> wrote:
  
Hello!   Robert I thought I'd mention that I've gone ahead and glommed a copy   of the router and source code to work with it. This will hopefully be   on an Pi, and possibly be on Win2K3 but that's about it for now....
  
I'm rolling mine hopefully to ultimately run it on RaspberryPi too. They do make excellent low powered DEC routers ^_^.
  
--        Mark Benson      http://DECtec.info
Twitter: @DECtecInfo
HECnet: STAR69::MARK      Online Resource & Mailing List for DEC  Enthusiasts.