[HECnet] Multinet alternatives ...

[Mark Berryman]

Does pydecnet support IPv6 yet?

Mark

> On Feb 25, 2020, at 9:01 AM, Keith Halewood <Keith.Halewood at pitbulluk.org> wrote:
> 
> I have pydecnet running on raspberry pi 3b+
> under raspbian with the bridge and tap support added. It does the job.
> 
> Keith
> 
>> On 25 Feb 2020, at 15:55, Paul Koning <paulkoning at comcast.net <mailto:paulkoning at comcast.net>> wrote:
>> 
>> 
>> 
>>>> On Feb 25, 2020, at 10:40 AM, Robert Armstrong <bob at jfcl.com> wrote:
>>>> 
>>>> 
>>>> 
>>>> -----Original Message-----
>>>> From: owner-hecnet at Update.UU.SE [mailto:owner-hecnet at Update.UU.SE] On Behalf Of Paul Koning
>>>> Sent: Tuesday, February 25, 2020 6:53 AM
>>>> To: hecnet at update.uu.se
>>>> Subject: Re: [HECnet] Multinet alternatives ...
>>>> 
>>>> 
>>>> 
>>>>> Paul Koning [paulkoning at comcast.net] wrote:
>>>> 
>>>> There was, but I think Python recently dropped VMS support due to lack of a maintainer.
>>> 
>>> Dropped VMS or dropped VAX?  There was a Python for AXP (although I don't know if it's still supported) but I don't think there was for VAX.
>>> 
>>> How do people who use your router typically run it?  Do they run it on Linux?  
>> 
>> Linux or Mac, including at least one example on Linux on a z/390, and another on Beaglebone Black.  But the point of the exercise was to create code that would run, unchanged, on anything that supports Python.  For example, while I avoid Windows if at all possible, it certainly should run there without trouble.  Or NetBSD, to pick just one other random example.
>> 
>>>> TOPS-10 is Phase IV, right?  Any of the common DECnet implementations should talk to that.
>>> 
>>> TOPS-10 v7.04 (or maybe 7.05) is Phase IV.  That's good news - I've wanted to set up a TOPS-10 simulation, but running a simh780 just to route DECnet for the DMR on TOPS-10 was not attractive.
>>> 
>>> I'd rather have TOPS-20 but as you say TOPS-20 on simh with networking is not very practical.
>> 
>> It does work well enough that I was able use it to verify Phase II support.  I plan to add intercept support for talking to non-adjacent nodes, but that isn't in yet.  A primitive version is easy, a proper version is quite a lot harder.
>> 
>>   paul

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sonic.net/pipermail/hecnet-list/attachments/20200225/66f85f2f/attachment.html>