[HECnet] Getting reconnected

[Madeline Autumn-Rose]

On Wed, 17 Nov 2021, Supratim Sanyal wrote:

> On 11/17/21 7:50 PM, Madeline Autumn-Rose wrote:
>
>> On Wed, 17 Nov 2021, Supratim Sanyal wrote:
>> 
>>> On 11/17/21 7:38 PM, Madeline Autumn-Rose wrote:
>>> 
>>>> On Thu, 18 Nov 2021, Johnny Billquist wrote:
>>>> 
>>>>> Someone else will need to answer the question about various Cisco 
>>>>> capabilities.
>>>>> 
>>>>> Can't even remember where you were hooked up to before, and we we should 
>>>>> resume that or find some other alternative.
>>>>> 
>>>> 
>>>> I was previously part of the Cisco mesh.
>>> 
>>> Yes - others on the mesh, including Brian, may respond; I had sent you the 
>>> email below recently, feel free to reestablish your tunnel to Area-31 and 
>>> others. Are you still at 50.131.218.138?
>>> 
>> 
>> 73.223.113.75 now.
>
>
> Updating and awaiting connection whenever you are ready. BTW, DECnet/Python 
> does GRE tunneling too.
>

cisco-tandem#ping 31.1023
Type escape sequence to abort.
Sending 5, 100-byte DECnet echos to atg 0 area.node 31.1023, timeout is 5 
seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 72/80/88 ms

Looks like everything still works.

> Thanks.
>
>
>
>>> Contact info updated, thanks.
>>> 
>> 
>> Thanks.
>> 
>>> Hi Cory,
>>> 
>>> I am not sure if Area-9 is reachable, but when you have a chance, can you 
>>> update your tunnel destination for Area-31 to 150.136.5.129 please? I have 
>>> moved
>>> 31.1023 to this IP (Oracle Cloud data center, Ashburn, Virginia).
>>> 
>>> Thanks.
>>> 
>>> Best regards,
>>> Supratim
>>> 
>>> interface Tunnel9
>>>  no ip address
>>>  logging event subif-link-status
>>>  decnet cost 9
>>>  decnet routing-timer 20
>>>  decnet router-priority 1
>>>  tunnel source FastEthernet0/1
>>>  tunnel destination 50.131.218.138
>>>  tunnel path-mtu-discovery
>>> 
>>> 
>>> 
>>> 
>>>>>  Johnny
>>>>> 
>>>>> On 2021-11-18 01:16, Madeline Autumn-Rose wrote:
>>>>>> Been awhile since I've posted anything, or been connected but I'd like 
>>>>>> to work on getting reconnected to HECnet.
>>>>>> 
>>>>>> I would still like to do Cisco connections - just need to pass that 
>>>>>> through the firewall. Can a more-modern ISR running IOS-XE do DECnet? 
>>>>>> (specifically a cisco 4321). Worst case I can just re-use the 2851, but 
>>>>>> that's got a lot of telephony config on it so would like to separate 
>>>>>> out uses if possible.
>>>>>> 
>>>>>> (Also - you may have previously known me as Cory Smelosky - please 
>>>>>> update contact details and whatnot)
>>>>>> 
>>>>>> I used to be area 9 - I will continue to use that area.
>>>>>> 
>>>>>> Thanks!
>>>>> 
>>>>> 
>>>> 
>>> 
>> 
>

-- 
Madeline Autumn-Rose
http://gewt.net Personal stuff
http://gimme-sympathy.org Projects