[HECnet] DECNet Issue - moving the system disk between two VMS boxes

[H Vlems]

NETCONFIG pretty much solves all problems...
The ethernet interface on a VAXstation 4000 model 60 is recognized by DECnet
as ESA0, so you'll see a LINE and a CIRCUIT called ESA-0.
The VAXstation 4000 model 90 uses different hardware and the device is known
as ISA-0 to DECnet.
You can manually create the corresponding LINE and CIRCUIT components with
NCP but running NETCONFIG is a lot faster, if not easier ;-)
Hans Vlems

-----Oorspronkelijk bericht-----
Van: owner-hecnet at Update.UU.SE [mailto:owner-hecnet at Update.UU.SE] Namens
Mark Wickens
Verzonden: zaterdag, mei 2010 11:42
Aan: hecnet at Update.UU.SE
Onderwerp: Re: [HECnet] DECNet Issue - moving the system disk between two
VMS boxes

OK,

So in time honoured tradition I solved the problem pretty much by asking
the question.

I did a NETCONFIG and a reboot and all is fine again.

Regards, Mark.

Geen virus gevonden in het binnenkomende-bericht.
Gecontroleerd door AVG - www.avg.com 
Versie: 9.0.819 / Virusdatabase: 271.1.1/2889 - datum van uitgifte: 05/22/10
08:26:00