[HECnet] Node 4.249

[Paul_Koning at Dell.com]

OOPS.

You're right of course.   I was thinking about multiple Ethernet interfaces on DIFFERENT LANs.   (Not different segments bridged, but not connected at L2, only at L3.)

	paul

On Aug 28, 2012, at 7:44 PM, Johnny Billquist wrote:

On 2012-08-28 17:58, Paul_Koning at Dell.com wrote:
Maybe the thing to do is to turn on both interfaces -- that will give you a dual-link end node, which is something DECnet handles just fine.   In fact, I've always argued that DECnet handles multiple connections to the same LAN much better than IP ever did, mostly because it addresses nodes rather than networks or interfaces.

Uh... I would argue that that would be a very bad thing, as it means you'll have two interfaces with the same mac address... Sitting on the same network. I'm pretty sure I even have seen some DECnet documentation that just says "not supported", or even stronger words...

	Johnny


	paul

On Aug 28, 2012, at 11:54 AM, Mark Benson wrote:

I tried to run a similar setup and found that Debian/Ubuntu's
'network-manager' process makes a really horrific mess of managing 2
interfaces.

I ripped it out of Debian and used file entries in
/etc/network/interfaces and /etc/resolv.conf

I have no idea if Ubuntu will spit it's brain out if you try that on
12.04 as it's ver dependent on it in the GUI.

--
Mark Benson

http://markbenson.org/blog
http://twitter.com/MDBenson

On 28 Aug 2012, at 13:37, Mark Wickens <mark at wickensonline.co.uk> wrote:

I think I've found it.

My HP Microserver running Ubuntu 12.04 has two network cards in: eth0 and eth2.



-- 
Johnny Billquist                                   || "I'm on a bus
                                                                ||   on a psychedelic trip
email: bqt at softjar.se                         ||   Reading murder books
pdp is alive!                                         ||   tryin' to stay hip" - B. Idol