rebuild RSTS/E monitor, was Re: [HECnet] RSTS/E 10.1 and OpenVMS via DECnet

[Jordi Guillaumes i Pons]

El 29/10/2012, a les 17:40, Cory Smelosky <b4 at gewt.net> va escriure:


29-Oct-2012 09:33:11 ***BUGCHK COMBNN*** Bad local node number   Job: 0, User: OPERATOR
[KNILDR: Loading microcode version 1(172) into Ethernet channel 0]

TYPE SYSTEM:7-1-CONFIG.CMD shows:
NODE MINDY 33.303
DECNET ROUTER-ENDNODE

ETHERNET 0 DECNET

Trying to enter opr so I can enter NCP and see if I can get more information   but nothing happens when I type opr<ret> as operator.

The system is not reachable via decnet.

Did I forget a setting somewhere?

Hmmmm...

@enable
$r opr
OPR>enter ncp
NCP>show executor char
NCP>
18:30:48               NCP

Request # 324; Show Executor Node Characteristics Completed

Executor Node = 7.78 (BITXT2)

  Identification = DECnet-20 Version 4.0
  Management Version = 4.0.0
  Loop Count = 1
  Loop Length = 127
  Loop With = Mixed
  Incoming Timer = 30
  Outgoing Timer = 60
  NSP Version = 4.0.0
  Maximum Links = 65535
  Delay Factor = 48
  Delay Weight = 10
  Inactivity Timer = 120
  Retransmit Factor = 10
  Routing Version = 2.0.0
  Type = Nonrouting IV
  Routing Timer = 600
  Broadcast Routing Timer = 40
  Maximum Address = 255
  Maximum Circuits = 20
  Maximum Cost = 100
  Maximum Hops = 16
  Maximum Visits = 20
  Maximum Broadcast Nonrouters = 64
  Maximum Broadcast Routers = 32
  Maximum Buffers = 80
  Buffer Size = 576
  Segment Buffer Size = 576                                                                                                                                                                   

That "Maximum Address" makes me wonder... try to assign to it an address under 255. 

If I try to change the characteristic I get an error:

NCP>set executor maximum address 1023
NCP>
18:31:21               NCP

Request # 325; Set Node Failed, Operation failure                                                                                                                       

I'll try to locate a DECNET-20 manual to check it all...

I have it attached to a bridge and it is reachable via TCP/IP, so networking works.


TCPIP access does not mean you will have DECNET access. There is that MAC Address change issue. That is what prevented my setup to work in the first place, so I had to go the VM way...



Jordi Guillaumes i Pons
jg at jordi.guillaumes.name
HECnet: BITXOV::JGUILLAUMES