[HECnet] Config tool

[Brian Hechinger]

And    done!

Sorry for the noise everyone!

Reason for change: Modified Tunnel52: Cory Smelosky (Area 9)
	"dynamic_ip" changed from "true" to    false"

-brian

On Mar 11, 2015, at 10:30 PM, Cory Smelosky <b4 at gewt.net> wrote:

On Wed, 11 Mar 2015, Brian Hechinger wrote:

Or perhaps not. DNS was saying 139 but it had 132 in the db. I   ve manually set it to 139 in the db. If that doesn   t settle it down I   ll mark you as static.


That'd explain things. ;)

Good thing it's a 2851 that can take it!

Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 15.1(4)M8, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2014 by Cisco Systems, Inc.
Compiled Fri 07-Mar-14 08:19 by prod_rel_team

Cisco 2851 (revision 1.0) with 473088K/51200K bytes of memory.
Processor board ID FHK1050F1JN
4 FastEthernet interfaces
2 Gigabit Ethernet interfaces
1 Serial interface
1 ATM interface
1 terminal line
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
125440K bytes of ATA CompactFlash (Read/Write)

Description: LAN :: Link to switch
Internet address is 10.10.0.1/16
MTU 9000 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
  reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID   1., loopback not set
Keepalive set (10 sec)
Full Duplex, 1Gbps, media type is T
output flow-control is XON, input flow-control is XON

Waiting for the gig of RAM to arrive!

-- 
Cory Smelosky
http://gewt.net Personal stuff
http://gimme-sympathy.org Projects