[HECnet] Cisco tunnels: update my IP

[Cory Smelosky]

175/10 cable with a constant ache to upgrade to gigabit from one of the providers. ;)

----- Original Message -----
> From: "Brian Hechinger" <wonko at 4amlunch.net>
> To: hecnet at Update.UU.SE
> Sent: Thursday, June 23, 2016 8:09:24 AM
> Subject: Re: [HECnet] Cisco tunnels: update my IP

> What sort of connection do you have?
> 
> -brian
> 
>> On Jun 23, 2016, at 10:55, Cory Smelosky <b4 at gewt.net> wrote:
>> 
>> ...it also exceeds the capabilities of a 2851.
>> 
>> Sent from my iPhone
>> 
>>> On Jun 23, 2016, at 07:26, Cory Smelosky <b4 at gewt.net> wrote:
>>> 
>>> My connection exceeds the capabilities of the 2620 or I would.
>>> 
>>> Sent from my iPhone
>>> 
>>>> On Jun 23, 2016, at 05:30, Peter Lothberg <roll at Stupi.SE> wrote:
>>>> 
>>>> 
>>>> Why don't you put your 2600 as your boarder-gw?
>>>> 
>>>> interface Tunnel1
>>>> ip address 192.108.195.70 255.255.255.252
>>>> ip router isis
>>>> ipv6 address 2001:440:1880:ABCD::2/64
>>>> ipv6 enable
>>>> ipv6 mtu 1420
>>>> ipv6 router isis
>>>> decnet cost 1
>>>> isis metric 2
>>>> tunnel source ATM0/1/0.1
>>>> tunnel destination 192.36.147.120
>>>> !
>>>> interface ATM0/1/0
>>>> mtu 4470
>>>> no ip address
>>>> ip virtual-reassembly in max-fragments 64 max-reassemblies 512
>>>> load-interval 30
>>>> atm restart timer 90
>>>> no atm ilmi-keepalive
>>>> dsl enable-training-log delay 0
>>>> dsl power-cutback 6
>>>> dsl noise-margin -2
>>>> dsl gain-setting rx-offset 3
>>>> dsl bitswap both
>>>> !
>>>> interface ATM0/1/0.1 point-to-point
>>>> mtu 4470
>>>> ip dhcp client broadcast-flag set
>>>> ip address dhcp
>>>> ip nat outside
>>>> ip virtual-reassembly in
>>>> atm route-bridged ip
>>>> pvc 0/35
>>>> protocol bridge
>>>> encapsulation aal5snap
>>>> 
>>>> -P
>>>> 
>>>> 
>>>> 
>>>> 
>>>>>> On 23/06/2016 1:47 PM, Cory Smelosky wrote:
>>>>>> Found the actual problem!
>>>>>> 
>>>>>> IPSec VTI VPNs means I can't do source-based NAT/firewall rules to redirect GRE
>>>>>> from the DECnet tunnel IPs to a separate box as is currently configured.
>>>>>> 
>>>>> 
>>>>> So, does this mean that you're still off the air?
>>>>> 
>>>>> Regards, Tim.
>>>>> 
>>>>> 
>>>> 
>>>> `
>>>