[HECnet] Cisco tunnels: update my IP

[Dave McGuire]

  Nice and all...but how much are you actually *using*? ;)

             -Dave

-- 
Dave McGuire, AK4HZ
New Kensington, PA



On June 23, 2016 11:13:04 AM Cory Smelosky <b4 at gewt.net> wrote:

> 175/10 cable with a constant ache to upgrade to gigabit from one of the
> providers. ;)
>
> ----- Original Message -----
>> From: "Brian Hechinger" <wonko at 4amlunch.net>
>> To: hecnet at Update.UU.SE
>> Sent: Thursday, June 23, 2016 8:09:24 AM
>> Subject: Re: [HECnet] Cisco tunnels: update my IP
>
>> What sort of connection do you have?
>>
>> -brian
>>
>>> On Jun 23, 2016, at 10:55, Cory Smelosky <b4 at gewt.net> wrote:
>>>
>>> ...it also exceeds the capabilities of a 2851.
>>>
>>> Sent from my iPhone
>>>
>>>> On Jun 23, 2016, at 07:26, Cory Smelosky <b4 at gewt.net> wrote:
>>>>
>>>> My connection exceeds the capabilities of the 2620 or I would.
>>>>
>>>> Sent from my iPhone
>>>>
>>>>> On Jun 23, 2016, at 05:30, Peter Lothberg <roll at Stupi.SE> wrote:
>>>>>
>>>>>
>>>>> Why don't you put your 2600 as your boarder-gw?
>>>>>
>>>>> interface Tunnel1
>>>>> ip address 192.108.195.70 255.255.255.252
>>>>> ip router isis
>>>>> ipv6 address 2001:440:1880:ABCD::2/64
>>>>> ipv6 enable
>>>>> ipv6 mtu 1420
>>>>> ipv6 router isis
>>>>> decnet cost 1
>>>>> isis metric 2
>>>>> tunnel source ATM0/1/0.1
>>>>> tunnel destination 192.36.147.120
>>>>> !
>>>>> interface ATM0/1/0
>>>>> mtu 4470
>>>>> no ip address
>>>>> ip virtual-reassembly in max-fragments 64 max-reassemblies 512
>>>>> load-interval 30
>>>>> atm restart timer 90
>>>>> no atm ilmi-keepalive
>>>>> dsl enable-training-log delay 0
>>>>> dsl power-cutback 6
>>>>> dsl noise-margin -2
>>>>> dsl gain-setting rx-offset 3
>>>>> dsl bitswap both
>>>>> !
>>>>> interface ATM0/1/0.1 point-to-point
>>>>> mtu 4470
>>>>> ip dhcp client broadcast-flag set
>>>>> ip address dhcp
>>>>> ip nat outside
>>>>> ip virtual-reassembly in
>>>>> atm route-bridged ip
>>>>> pvc 0/35
>>>>> protocol bridge
>>>>> encapsulation aal5snap
>>>>>
>>>>> -P
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>>> On 23/06/2016 1:47 PM, Cory Smelosky wrote:
>>>>>>> Found the actual problem!
>>>>>>>
>>>>>>> IPSec VTI VPNs means I can't do source-based NAT/firewall rules to redirect GRE
>>>>>>> from the DECnet tunnel IPs to a separate box as is currently configured.
>>>>>>>
>>>>>>
>>>>>> So, does this mean that you're still off the air?
>>>>>>
>>>>>> Regards, Tim.
>>>>>>
>>>>>>
>>>>>
>>>>> `
>>>>