[HECnet] Cisco tunnels: update my IP

[Johnny Billquist]

Corey, you need to check the time on your system. You mails are in the 
future...

	Johnny

On 2016-06-23 18:14, Cory Smelosky wrote:
> I need to keep the router and switch maintained so I don't get calls at 4am because my dad needs to check sports scores. ;)
>
> ----- Original Message -----
>> From: "Dave McGuire" <mcguire at neurotica.com>
>> To: hecnet at Update.UU.SE
>> Sent: Thursday, June 23, 2016 8:33:28 AM
>> Subject: Re: [HECnet] Cisco tunnels: update my IP
>
>> "Downloading the entire Internet"...I love it. :)
>>
>>  I didn't know you were still running hardware at your old place in Ohio..?
>>
>>           -Dave
>>
>> On 06/23/2016 12:09 PM, Cory Smelosky wrote:
>>> With ZFS replication across work/home and home/old Ohio stuff, downloading the
>>> entire internet, and being impatient...I do quite regularly max it out. ;)
>>>
>>> ----- Original Message -----
>>>> From: "Dave McGuire" <mcguire at neurotica.com>
>>>> To: hecnet at Update.UU.SE
>>>> Sent: Thursday, June 23, 2016 8:14:53 AM
>>>> Subject: Re: [HECnet] Cisco tunnels: update my IP
>>>
>>>> Nice and all...but how much are you actually *using*? ;)
>>>>
>>>>             -Dave
>>>>
>>>> --
>>>> Dave McGuire, AK4HZ
>>>> New Kensington, PA
>>>>
>>>>
>>>>
>>>> On June 23, 2016 11:13:04 AM Cory Smelosky <b4 at gewt.net> wrote:
>>>>
>>>>> 175/10 cable with a constant ache to upgrade to gigabit from one of the
>>>>> providers. ;)
>>>>>
>>>>> ----- Original Message -----
>>>>>> From: "Brian Hechinger" <wonko at 4amlunch.net>
>>>>>> To: hecnet at Update.UU.SE
>>>>>> Sent: Thursday, June 23, 2016 8:09:24 AM
>>>>>> Subject: Re: [HECnet] Cisco tunnels: update my IP
>>>>>
>>>>>> What sort of connection do you have?
>>>>>>
>>>>>> -brian
>>>>>>
>>>>>>> On Jun 23, 2016, at 10:55, Cory Smelosky <b4 at gewt.net> wrote:
>>>>>>>
>>>>>>> ...it also exceeds the capabilities of a 2851.
>>>>>>>
>>>>>>> Sent from my iPhone
>>>>>>>
>>>>>>>> On Jun 23, 2016, at 07:26, Cory Smelosky <b4 at gewt.net> wrote:
>>>>>>>>
>>>>>>>> My connection exceeds the capabilities of the 2620 or I would.
>>>>>>>>
>>>>>>>> Sent from my iPhone
>>>>>>>>
>>>>>>>>> On Jun 23, 2016, at 05:30, Peter Lothberg <roll at Stupi.SE> wrote:
>>>>>>>>>
>>>>>>>>>
>>>>>>>>> Why don't you put your 2600 as your boarder-gw?
>>>>>>>>>
>>>>>>>>> interface Tunnel1
>>>>>>>>> ip address 192.108.195.70 255.255.255.252
>>>>>>>>> ip router isis
>>>>>>>>> ipv6 address 2001:440:1880:ABCD::2/64
>>>>>>>>> ipv6 enable
>>>>>>>>> ipv6 mtu 1420
>>>>>>>>> ipv6 router isis
>>>>>>>>> decnet cost 1
>>>>>>>>> isis metric 2
>>>>>>>>> tunnel source ATM0/1/0.1
>>>>>>>>> tunnel destination 192.36.147.120
>>>>>>>>> !
>>>>>>>>> interface ATM0/1/0
>>>>>>>>> mtu 4470
>>>>>>>>> no ip address
>>>>>>>>> ip virtual-reassembly in max-fragments 64 max-reassemblies 512
>>>>>>>>> load-interval 30
>>>>>>>>> atm restart timer 90
>>>>>>>>> no atm ilmi-keepalive
>>>>>>>>> dsl enable-training-log delay 0
>>>>>>>>> dsl power-cutback 6
>>>>>>>>> dsl noise-margin -2
>>>>>>>>> dsl gain-setting rx-offset 3
>>>>>>>>> dsl bitswap both
>>>>>>>>> !
>>>>>>>>> interface ATM0/1/0.1 point-to-point
>>>>>>>>> mtu 4470
>>>>>>>>> ip dhcp client broadcast-flag set
>>>>>>>>> ip address dhcp
>>>>>>>>> ip nat outside
>>>>>>>>> ip virtual-reassembly in
>>>>>>>>> atm route-bridged ip
>>>>>>>>> pvc 0/35
>>>>>>>>> protocol bridge
>>>>>>>>> encapsulation aal5snap
>>>>>>>>>
>>>>>>>>> -P
>>>>>>>>>
>>>>>>>>>
>>>>>>>>>
>>>>>>>>>
>>>>>>>>>>> On 23/06/2016 1:47 PM, Cory Smelosky wrote:
>>>>>>>>>>> Found the actual problem!
>>>>>>>>>>>
>>>>>>>>>>> IPSec VTI VPNs means I can't do source-based NAT/firewall rules to redirect GRE
>>>>>>>>>>> from the DECnet tunnel IPs to a separate box as is currently configured.
>>>>>>>>>>>
>>>>>>>>>>
>>>>>>>>>> So, does this mean that you're still off the air?
>>>>>>>>>>
>>>>>>>>>> Regards, Tim.
>>>>>>>>>>
>>>>>>>>>>
>>>>>>>>>
>>>>>>>>> `
>>
>> --
>> Dave McGuire, AK4HZ
>> New Kensington, PA